4406 HWY 14, New Iberia, LA 70560
phone:  (337)-364-5841  fax:  (337)-367-2888

email:  meredith@javeler.com

Home About Us Contacts Dredging Equipment Dredging Projects Dredging Services Newsletter

 Barge Offloading

Home
About Us 
Contacts
Dredging Equipment
Dredging Services
Dredging Projects
Barge Unloading
Upland Disposal Sites
Barge Loading & Unloading
Deep Water Dredging
    4700 Feet Deep
Stuck jack up leg
  Environmental Dredging
    Contaminated Sediment
    Wetland Restoration
   
Burying live gas pipeline
    Filling Geotubes
Offshore Dredging
Uncover buried jack up leg
Drilling Rigs
    Pipeline Burial & Retrieval
    Burying live gas pipeline
Deep Water Dredging
Maintenance Dredging  
Dredging at Ports
Marine Terminals
Dock Frontage Dredging
Dredging for Neighborhoods
Specialty Dredging
Hazardous Material
Dredging To New Depths
Sand & Gravel Excavation
Jetty& Beach Nourishment
Sediment Removal at Dams
    Small Spaces
    Bridge Construction
Newsletter 
 

Barge Unloading at The Port of Portland

Javeler Construction Co., Inc. provided the equipment (Toyo Pump) and technical support on this Port of Portland barge unloading project.  A six yard cable arm bucket is used to dredge material that has built up along side the dock at one of their terminals and is deposited into a 1,500 cubic yard capacity barge with seven cells.  The10" pumping system is used to unload the thick mud at a rate of 280 cubic yards per hour, 600' to a disposal pond. The system is quiet and there is no spillage back into the river. 

Barge Unloading - Portland  Toyo 75 HP submersible pump   Toyo Pump in material   ToyoPump Dredge Discharge
Please Click on Thumbnail Photo to Enlarge!

Barge Unloading
Barge Unloading in Lafourche Parish, Louisiana

 Toyo Pump Barge Unloading       Barge Offloading Toyo Pumps
Please Click on Thumbnail Photo to Enlarge!

Barge Loading/Unloading Project - Upland Disposal

A Toyo hydraulic driven 10 inch submersible agitator pump is being used to dredge a navigational channel 40' wide by 1200' long, to minus 8 feet. The Toyo submersible is hung from a 40 ton crane. Hydraulic power unit (from a vibratory hammer) is located on the back of the crane. Material is silts/sand/oyster shells. Loading thick slurry into a 200' x 40' barge located 1200 feet away. Weirs inside the barge assist in dewatering. Barge is transported 5 miles to an upland disposal site, where the same set up is used for unloading. Final disposal site is 1,000 feet away.

Toyo Pump DP-150B      TOYO Pumps 10" discharge
Please Click on Thumbnail Photo to Enlarge!

Upland Disposal Dredging Project - Baltimore Area

Thirty thousand yards of sand and silt were dredged with a clam shell and placed into barges.  The barges were taken to the upland disposal site.   The dredge spoils were then transferred through bridge grating into a hopper barge containing Javeler's 10 inch 150 horsepower submersible agitator dredge pump.  The dredge pump transferred over 250 cubic yards per hour of material through an in line booster pump, and through 2,200 feet of 10" HDPE pipe to the disposal site.

Dredging with Toyo Pumps     Dredging with Toyo Pumps     Dredging with Toyo Pumps     Dredging with Toyo Pumps     Dredging with Toyo Pumps
Please Click on Thumbnail Photo to Enlarge!

Barge Unloading in South Texas

Barge Unlaoding Texas


Meredith Cross Oubre
Copyright © 2007 [Javeler Construction Co., Inc]. All rights reserved.
Information in this document is subject to change without notice.
Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark holders.